2n Helios IP Configuration Manual v2.7 Manuel d'utilisateur télécharger pdf (Page 36)

362N TELEKOMUNIKACE a.s., www.2n.cz

The table above includes a list of universal codes that help you activate switches from

the phone or intercom keypad. Up to 10 universal codes can be defined for each switch

(depending on the particular intercom model).

Code – enter a numeric code for the switch. The code must include 2 characters

at least but we recommend you to use four characters at least to make the code

accessible from the intercom numeric keypad. Codes 00 and 11 can't be entered

from numeric keypad. Code is confirmed with *.

Accessibility – block the switch activation code entering from the intercom

numeric keypad or your phone.

Time profile – assign a time profile to the switch code to control its validity.

Activation by call – enable switch activation by an incoming or outgoing call,

for example. During an outgoing call the switch is activated after SIP message

180 Ringing is received. The called party confirms ringing by this message. The

switch is active during the whole call in the bistable mode, and activated by the

call beginning and deactivated after the predefined switch-on duration in the

monostable mode.

Note

– be sure to set the internal power supply andHelios IP Vario

switching relay on the configuration connector.

– the security relay is connected to the DOOR +Helios IP Force

and - terminals.

Note

The extended switch activation is available with the Gold or Enhanced

Integration licence only.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 114 115

Pas de commentaire

2n Helios IP Configuration Manual v2.7 Manuel d'utilisateur Page 36