2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manuel d'utilisateur télécharger pdf (Page 34)

342N TELEKOMUNIKACE a.s., www.2n.cz

This command displays the currently set interface values.

^SCCFG: "MODE",1

^SCCFG: "GPRS_APN","publicip.t-mobile.cz"

^SCCFG: "GPRS_USER","internet"

^SCCFG: "GPRS_PASS","hfsdj515d"

^SCCFG: "LOCAL_IP","89.24.3.195"

^SCCFG: "SIM_PIN","1234"

^SCCFG: "AUTH_IP",0

at^sccfg=?

This command displays the port value setting options.

^SCCFG: "MODE",1-3

^SCCFG: "GPRS_APN","32"

^SCCFG: "GPRS_USER","32"

^SCCFG: "GPRS_PASS","32"

^SCCFG: "LOCAL_IP"

^SCCFG: "SIM_PIN","16"

^SCCFG: "AUTH_IP,0-1

^SCCFG: "SAVE"

^SCCFG: "RESTART"

^SCCFG: "SRESTART"

Port 1 (RS 232) SC Commands

These commands are used for setting the RS 232 parameters.

at^scport1="baudrate",9600

Enter the command to set the baud rate to 9,600 bps.

at^scport1="baudrate",115200

Enter the command to set the baud rate to 115,200 bps.

at^scport1="baudrate",230400

Enter the command to set the baud rate to 230 400bps.

The baud rate can be set to 110 – 230,400 in standard steps.

at^scport1="data_bits",8

Enter the command to set the data bits to 8. Setting options: 5-8.

at^scport1="stop_bits",2

Enter the command to set the stop bits to 2. Setting options: 1-2.

at^scport1="parity",2

Enter the command to set the parity check type. Setting options: 0-4.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 148 149

Pas de commentaire

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manuel d'utilisateur Page 34