2n Helios IP Configuration Manual v2.8 Manuel d'utilisateur télécharger pdf (Page 4)

42N TELEKOMUNIKACE a.s., www.2n.cz

1. Product Overview

The door intercoms can smartly replace traditional doorbell2N Helios IP

push-button speakerphone panels and all wiring, bells and home intercom installations

in buildings with structured cabling. The intercoms provide more advanced and wider

services than standard home phones. The installation is very easy, all you need is

connect the intercom to the other LAN elements using a UTP cable and set necessary

parameters.

Thanks to the integrated SIP protocol, the intercom can make use of all VoIP services:

call forwarding at absence (to another office, VoiceMail or a cellular phone) or call

transfer (from the secretary’s office to the required person, e.g.).

The intercoms are equipped with a programmable number of quick dial buttons for

speed calling to the users whose numbers are included in the intercom Phone Book.

Each of the quick dial buttons can be assigned up to three phone numbers, which can

be dialled in parallel or sequentially. Thanks to an integrated time sheet it is possible to

configure each of the buttons in such a way that the called party is always accessible

and/or calls to selected phone numbers can be barred off the working hours.

Some models are equipped with a numeric keypad, which can be used2N Helios IP

as a code lock or a standard push-button phone.

The intercoms help LAN users scan the area in front of the camera via 2N Helios IP

video streaming. Thanks to the full ONVIF support, the intercoms can become part of

the Video Surveillance System in your facility .

The intercoms can be equipped with an RFID card reader for authorised2N Helios IP

access control and thus become a key part of your surveillance or attendance control

systems.

The intercom is equipped with a relay switch (and, optionally, other2N Helios IP

relays and outputs), which controls the electric lock or other equipment connected to

the intercom. Its activation time and method can be programmed flexibly: it can be

activated by a code, automatically by a call, by pressing a button, and so on.

The following symbols and pictograms are used in the manual:

1 2 3 4 5 6 7 8 9 ... 113 114

Pas de commentaire

2n Helios IP Configuration Manual v2.8 Manuel d'utilisateur Page 4