2n VoiceBlue Next v3.1 Manuel d'utilisateur télécharger pdf (Page 55)

552N TELEKOMUNIKACE a.s., www.2n.cz

Table of replaced prefixes

This table helps you change the prefix of the number received (from 00 to +, e.g.). You

can just add or remove a prefix using this table. This change is performed before the

prefix table search is initiated. Keep the „"/ „" record at least in the table for a proper

function.

Table of accepted prefixes

A list of prefixes of called destinations to which the selected prefix list applies.

LCR table

The LCR (Least Cost Routing) table helps route calls according to the called number

and depending on the day time and weekday.

Prefix list – select a list of prefixes to be used for the selected LCR row.

Time limitation – set a time limitation for a particular LCR row.

Weekend usage – enable/disable a particular PCR row during weekends.

Maximum call length – set the maximum length (in minutes) for an active

outgoing call to GSM/UMTS.

Groups – set the GSM outgoing groups to be used for the selected LCR row.

Tariffs – select the tariff group (free minute counter) to be used for the outgoing

call. Refer to the for more details.GSM outgoing groups

Ignore tone detection in last group – having detected a user defined tone (refer

to ), the GSM gateway terminates the call and seeks forGSM basic settings

another call setup option by default. If this parameter is activated, the GSM

gateway ignores the tone detection results and sets up the call if this is the last

call setup option.

Note

You are recommended to read the Routing Algorithm for

section on p. before setting the LCR table andOutgoing Calls

prefix lists.

Remember to set the tariffs correctly in the GSM outgoing

section to make tariff routing work properly.groups

CLIP routing table + CallBack

The table permanently assigns CLIPs to the extensions to which incoming calls are to

be routed automatically and set the CLIP list for the GMS network for which the

CallBack function is enabled.

GSM number (CLIP) – user identification in a GSM/UMTS network.

AutoDial – enable/disable CLIP routing for the selected CLIP.

Dial to VoIP – enter the VoIP destination number for CLIP routing.

Auto CallBack – enable/disable CallBack for the selected CLIP.

Limit – set the maximum call length (in minutes).

Note

Remember to activate the CallBack mode in the GSM incoming

window for a proper CallBack function.groups

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 91 92

Pas de commentaire

2n VoiceBlue Next v3.1 Manuel d'utilisateur Page 55